03 Workshop service
Repair & maintenance —
motors and drives.
Our workshop handles the full repair cycle for industrial motors, generators, dynamos, VFDs and soft starters. Bring the unit in, or we will come look at the installation — every job is quoted before work starts.
· Service categories
Four workshop tracks —
motors to electronics.
Most jobs fall into one of four tracks. Each one follows the same measured workflow: inspection, quote, repair, test, sign-off.
Induction Motor Repair & Rewinding
Full-cycle restoration of three-phase and single-phase induction motors — from diagnosis to bench-test and run-in.
- Stator rewinding to original or upgraded specification
- Insulation cleaning, varnishing and oven curing
- Bearing replacement and shaft inspection
- Dynamic balancing and vibration check
- Megger / surge / no-load test before delivery
Generator Repair & Maintenance
Electrical and mechanical service for generators — keeping your standby and prime power assets ready when the grid is not.
- AVR diagnosis and replacement
- Stator / rotor rewinding
- Bearing and brush service
- Insulation testing and rebuild
- Load-bank style verification on the bench
Dynamo Repair
Specialist DC machine work — commutator dressing, brush rigging service, armature rewind and field-coil rebuild.
- Commutator skim, undercut and polish
- Armature rewinding
- Field coil rebuild
- Brush gear alignment
- DC test and run-in
VFD & Soft Starter Repair
Component-level repair of failed inverters and soft starters — IGBT modules, gate drivers, control boards and DC bus capacitors.
- IGBT / SCR module replacement
- Gate driver and control board fault tracing
- DC bus capacitor refurbishment
- Cooling fan & thermal management
- Parameter restore and load test
· Our repair loop
Seven steps from
in-the-door to out-the-door.
01
Inspect
Visual, electrical and mechanical inspection on arrival.
02
Diagnose
Insulation, surge, no-load and load checks to confirm fault.
03
Photograph
Before-and-after documentation kept on file for every job.
04
Quote
Itemised quote with parts, labour, lead time and warranty.
05
Repair
Rewind, machine, replace and reassemble using original specs.
06
Test
Bench test, run-in, vibration and electrical sign-off.
07
Deliver
Packed, labelled and ready — delivery or pickup.
· From the workshop
Recent service & supply work.
Need a repair quote today?